Ethernet Port：RJ45
POE Power：Supported
POE Input：12V@1A
Network Speed： 100Mbps
Livestream protocol： RTSP, RTMP, H.264
Mic： Internal and External
USB ： Mini USB
Size： 43（W）* 82.2（L）* 31.4（H）mm
Weight：120g

Package Contents
Ethernet Module
Ghost 4K+ Camera

Accessories bag
USB cable
Ethernet cable
POE Power Adaptor
POE Splitter

Install your Ethernet Module
1.Remove the original battery module from your Ghost 4K+ camera.

2.Place Drift Ethernet Module on the camera body, ensuring that the module’s 30pin connector is above the camera’s female connector, put down on both ends simultaneously till the module clicks into place.

3.Connect your Ethernet cable (Not included in the package) to the port of Ethernet module, another end to the port of POE Splitter (opposite to the power port)

4.Connect the Ethernet cable on your POE Splitter to a router, and make sure the master device, either a computer or mobile phone, wired or wirelessly, is connected to the router as well.

5.Supply power to the POE splitter through the Power adaptor.

6.Your camera will automatically power on and join the network, after that (rear LED becomes solid green), you can find the last 8 bits of your camera’s IP address from camera’s rear LCD.